Difference between revisions of "Grm"
| Line 27: | Line 27: | ||
http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure23.jpg | http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure23.jpg | ||
| − | <center>'''CAUTION: Do not exceed the specified housing spread in Step 7. | + | <center>'''CAUTION: Do not exceed the specified housing spread in Step 7.''' |
| − | Spreading the housing greater amount than specified can cause damage or distortion.'''</center> | + | '''Spreading the housing greater amount than specified can cause damage or distortion.''' |
| + | </center> | ||
Revision as of 00:10, 21 July 2006
1980-1983 AMC Eagle's
The Differential repair requires special skills and specialty tools.
The inspection procedures found elsewhere in the AMC Eaglepedia will tell if repairs are necessary.
http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure10.jpg
http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure11.jpg
1.- Remove the axle assembly.
2.- Remove the axle housing cover bolts and cover.
3.- Mark the differential bearing caps with a centerpunch for reassembly alignment reference.
4.- Loosen but do not remove the fiferential bearing cap bolts.
5.- Install an axle housing spreader (tool part No. J-24385-01) and spreader adapters (toll part No. J-24161) as shown in [b]Figure 23.[/b] Used hold-down clamps to keep spreader in position.
6.- Install a dial indicator as shown in [b]Figure 23.[/b] Zero the indicator gauge. make sure the indicator plunger touches one side of the housing opening
http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure23.jpg
Spreading the housing greater amount than specified can cause damage or distortion.
7.- Slowly spread the housing 0.020 in. (0.50 mm) while watching the indicator. Remove the dial indicator when housing spread is complete.
8.- Remove and tag the differential bearing caps for reassembly reference.
9.- Position one pry bar under the ring gear bolt head and a second pry bar under the differential case. remove the differential assembly from the housing.
10.- Remove the spreader tool to prevent the possibility of housing distortion.
11.- Installation is the reverse of removal. Tighten all fasteners to specifications.
http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialtable1.jpg
