Difference between revisions of "Rear Axle/Differential R&R"
| Line 2: | Line 2: | ||
The Differential repair requires special skills and specialty tools. | The Differential repair requires special skills and specialty tools. | ||
| − | |||
The inspection procedures will tell if repairs are necessary. | The inspection procedures will tell if repairs are necessary. | ||
| − | |||
| − | |||
<center>'''Rear Axle Differetial/Removal/Installation:'''</center> | <center>'''Rear Axle Differetial/Removal/Installation:'''</center> | ||
| − | |||
| − | |||
http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure13.jpg | http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure13.jpg | ||
| − | |||
| − | |||
The differential can be checked and overhauled without removing the rear axle assembly. Refer to <b>Figure 13</b> for part names and location. | The differential can be checked and overhauled without removing the rear axle assembly. Refer to <b>Figure 13</b> for part names and location. | ||
| Line 31: | Line 24: | ||
11.- Installation is the reverse of removal. tighten all fasteners to specifications. | 11.- Installation is the reverse of removal. tighten all fasteners to specifications. | ||
| − | + | http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialtable1.jpg | |
Revision as of 04:25, 21 July 2006
1980-1983 AMC Eagle's
The Differential repair requires special skills and specialty tools.
The inspection procedures will tell if repairs are necessary.
http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure13.jpg
The differential can be checked and overhauled without removing the rear axle assembly. Refer to Figure 13 for part names and location.
1.- Remove the axle shaft dust caps. Lossen the wheel nuts. 2.- Raise the rear of the vehicle and place it on jackstands. 3.- Drain the axle housing. 4.- Remove the axle cover. 5.- Remove the wheels, brake drums, hubs, axel shaft and seals. Keep the axel parts separated according to the side of the vehicle from which they were removed. 6.- Mark the bearing caps with a centerpunch for reassembly reference. 7.- Loosen the bearing cap bolts until only a few threads remain engaged. Pull caps away from bearings. This will prevent the differential assembly from falling out in set 8. 8.- Pry the differential loose in the axle housing with a pry bar. 9.- Remove the bearing caps. remove the differential assembly. 10.- Tie the bearing shims to their respective caps and cups to prevent them from being mixed up or misplaced. 11.- Installation is the reverse of removal. tighten all fasteners to specifications.
http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialtable1.jpg
