|
|
| (3 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| | 1980-1983 AMC Eagle's | | 1980-1983 AMC Eagle's |
| | | | |
| − | The Differential repair requires special skills and specialty tools.
| + | Db> Zero |
| − |
| + | |
| − | The inspection procedures found elsewhere in the AMC Eaglepedia will tell if repairs are necessary.
| + | |
| − | | + | |
| − | <center>'''Front Axle Differetial/Removal/Installation:'''</center>
| + | |
| − | | + | |
| − | http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure10.jpg
| + | |
| − | | + | |
| − | | + | |
| − | http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure11.jpg
| + | |
| − | | + | |
| − | 1.- Remove the axle assembly.
| + | |
| − | | + | |
| − | 2.- Remove the axle housing cover bolts and cover.
| + | |
| − | | + | |
| − | 3.- Mark the differential bearing caps with a centerpunch for reassembly alignment reference.
| + | |
| − | | + | |
| − | 4.- Loosen but do not remove the fiferential bearing cap bolts.
| + | |
| − | | + | |
| − | 5.- Install an axle housing spreader (tool part No. J-24385-01) and spreader adapters (toll part No. J-24161) as shown in <b>Figure 23.</b> Used hold-down clamps to keep spreader in position.
| + | |
| − | | + | |
| − | 6.- Install a dial indicator as shown in [b]Figure 23.[/b] Zero the indicator gauge. make sure the indicator plunger touches one side of the housing opening
| + | |
| − | | + | |
| − | | + | |
| − | http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure23.jpg
| + | |
| − | | + | |
| − | <center>'''CAUTION: Do not exceed the specified housing spread in Step 7.'''
| + | |
| − | | + | |
| − | '''Spreading the housing greater amount than specified can cause damage or distortion.'''
| + | |
| − | </center>
| + | |
| − | | + | |
| − | | + | |
| − | 7.- Slowly spread the housing 0.020 in. (0.50 mm) while watching the indicator. Remove the dial indicator when housing spread is complete.
| + | |
| − | | + | |
| − | 8.- Remove and tag the differential bearing caps for reassembly reference.
| + | |
| − | | + | |
| − | 9.- Position one pry bar under the ring gear bolt head and a second pry bar under the differential case. remove the differential assembly from the housing.
| + | |
| − | | + | |
| − | 10.- Remove the spreader tool to prevent the possibility of housing distortion.
| + | |
| − | | + | |
| − | 11.- Installation is the reverse of removal. Tighten all fasteners to specifications.
| + | |
| − | | + | |
| − | | + | |
| − | http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialtable1.jpg
| + | |
