Difference between revisions of "Cherokee gas tank retrofit"
(New page: I happened to have an almost brand new gas tank out of Cherokee laying around, and since my current Cherokee has a plastic tank, I doubt I'll need it anytime soon. Dragged it out from behi...) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | I happened to have an almost brand new gas tank out of Cherokee laying around, and since my current Cherokee has a plastic tank, I doubt I'll need it | + | |
| + | By Eagle Nest member 'shaggimo'. | ||
| + | |||
| + | I happened to have an almost brand new gas tank out of a Cherokee laying around, and since my current Cherokee has a plastic tank, I doubt I'll need it any time soon. Dragged it out from behind the barn, it's just about the right size, so I did a test fit, clears everything quite nicely, exhaust, axle, stub rails, seems good. I also saved the sending unit that was in the tank, along with the filler neck, and straps. After a few mods, it's just about ready for installation, just needs undercoating. | ||
[[Image:Shag1.jpg]] | [[Image:Shag1.jpg]] | ||
| Line 11: | Line 14: | ||
[[Image:Shag3.jpg]] | [[Image:Shag3.jpg]] | ||
| − | Removed the electric pump, cut a piece of the Cherokee's filler hose for spacer so I could keep the factory type strainer. | + | Removed the electric pump, cut a piece of the Cherokee's filler hose for a spacer so I could keep the factory type strainer. |
Plus this swap will also make it easier if I want to install a 4.0 set up later on, just reinstall the fuel pump. | Plus this swap will also make it easier if I want to install a 4.0 set up later on, just reinstall the fuel pump. | ||
The tank does hang a little lower than the stock one, but this one's not meant to be a rock crawler anyway so it's no biggie. | The tank does hang a little lower than the stock one, but this one's not meant to be a rock crawler anyway so it's no biggie. | ||
Latest revision as of 20:16, 4 May 2010
By Eagle Nest member 'shaggimo'.
I happened to have an almost brand new gas tank out of a Cherokee laying around, and since my current Cherokee has a plastic tank, I doubt I'll need it any time soon. Dragged it out from behind the barn, it's just about the right size, so I did a test fit, clears everything quite nicely, exhaust, axle, stub rails, seems good. I also saved the sending unit that was in the tank, along with the filler neck, and straps. After a few mods, it's just about ready for installation, just needs undercoating.
I capped off the original location for the filler neck.
Drilled two new holes, and welded in the filler from the Cherokee.
Removed the electric pump, cut a piece of the Cherokee's filler hose for a spacer so I could keep the factory type strainer. Plus this swap will also make it easier if I want to install a 4.0 set up later on, just reinstall the fuel pump. The tank does hang a little lower than the stock one, but this one's not meant to be a rock crawler anyway so it's no biggie.
