Difference between revisions of "Pinion Seal Replacement"

Revision as of 00:45, 28 September 2006

Written by AMC Eagle Nest Member "Trapper Jack"

Things you will need

Seal I used from Advance Auto--part #470331N (Federal-Mogul)

1 1/8" socket for pinion nut

3/8 socket for u-joint

Tape to tape up caps on u-joint (don't want to lose the innards)

Drain pan to catch gear oil.

Breaker bar, torque wrench, impact wrench if you can round one up.

Paint or something to matchmark before removal.

Your starting point will probably look something like mine did

You'll want to clean up a little under there, and then mark what you've got so it goes back in the right place. I used yellow paint because I had yellow paint.

Next, remove the u-joint and tape the caps so you don't end up crawling around under the bird looking for that last little piece. If I'd had the money, this would have been a great time to replace the u-joints.