Difference between revisions of "Pinion Seal Replacement"
From Eaglepedia
| Line 21: | Line 21: | ||
[[Image:pinionseal02.jpg|frame|left]] | [[Image:pinionseal02.jpg|frame|left]] | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
Revision as of 00:39, 28 September 2006
Written by AMC Eagle Nest Member "Trapper Jack"
Things you will need
Seal I used from Advance Auto--part #470331N (Federal-Mogul)
1 1/8" socket for pinion nut
3/8 socket for u-joint
Tape to tape up caps on u-joint (don't want to lose the innards)
Drain pan to catch gear oil.
Breaker bar, torque wrench, impact wrench if you can round one up.
Paint or something to matchmark before removal.
Your starting point will probably look something like mine did
You'll want to clean up a little under there, and then mark what you've got so it goes back in the right place. I used yellow paint because I had yellow paint.
